Sharp CP-SR421 Instrukcja Użytkownika Pobierz pdf (Strona 308)

100

101

14. USING A LINEAR SERVO MOTOR

14 - 21

Output signals can be switched on/off forcibly independently of the servo status. This function is

used for output signal wiring check, etc. Exercise control on the DO forced output screen of MR

Configurator2.

Positioning operation can be performed in two or more operation patterns combined, without using

the servo system controller. Use this operation with the forced stop reset. This operation may be

used independently of whether the servo is on or off and whether the servo system controller is

connected or not.

Exercise control on the program operation screen of MR Configurator2. For full information, refer to

the MR Configurator2 Installation Guide.

Operation Screen control

Start Click the "Operation start" button.

Pause Click the "Pause" button.

Stop Click the "Stop" button.

Forced stop Click the "Forced stop" button.

(2) Operation procedure

1) Turn off the power.

2) Turn "ON (up)" SW2-1.

SW2-1ࠍ"ࠝࡦ(਄)"ߦ⸳ቯ

2 3 4

Turning "ON (up)" SW2-1 during power-on will not enable the test operation mode.

3) Turn on the servo amplifier.

When initialization is over, the display shows the following screen.

1.6⑽ᓟ

0.2⑽ᓟ

ὐṌ

4) Start operation with the personal computer.

Set SW2-1 to "ON (up)".

fter 1.6 s

fter 0.2 s

Flickering

1 2 ... 303 304 305 306 307 308 309 310 311 312 313 ... 403 404

Komentarze do niniejszej Instrukcji

Brak uwag

Sharp CP-SR421 Instrukcja Użytkownika Strona 308

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Nie Sharp CP-SR421