Sharp YO-370 Instrukcja Obsługi Pobierz pdf (Strona 22)

10 Revision 10 – 1/09/2015 FTS 370d/w/r

PCB3 Smart Board

The optional PCB3 “Smart Board” (PN

2424500) is installed on top of PCB1 of

the SC 370 programmed as System 1. It

provides an interface to the following

advanced monitoring capabilities not

available on the standard system: Cellular

Eagle 2.0, RS 485 Modbus RTU, Ethernet

SNMP, Ethernet Eagle 2.0 and Ethernet

Modbus. The GPS enabled Smart Board

(PN 2424501), shown in Figure 1-5,

provides the same capabilities as the

standard Smart Board with the addition of

GPS synchronization. Either smart board

is required for the optional cellular modem

and/or WiFi interface. The GPS enabled

Smart Board is strongly recommended for

Catenary systems.

GPS Sync. Kit

The FTS 370 system can be ordered with

GPS Synchronization factory installed. It

is also available as an upgrade for existing

FTS 370 systems. The kit (PN 1370185)

includes instructions and all components

necessary for installation. Antenna

installation instructions are provided in

Section 2 “GPS Antenna” for systems

ordered with GPS Sync factory installed.

Two LEDs: Antenna Open and Antenna

Short, provide status of the GPS antenna.

The Ant. Open will be lit if the GPS

antenna is not connected or is not properly

connected to the antenna connector. It

will also indicate a broken or damaged

wire to the antenna. The Ant. Short will

be lit if the antenna cable is shorted.

Neither LED should be lit in if the antenna

is functioning correctly.

USB Port

The USB port provides access to update

the system’s firmware. See Section 3

USB Firmware Update for additional

information regarding this feature.

Figure 1-5 – PCB 3 with GPS

Ethernet

Connection

GPS Synchronization

(PN 2425401 Only)

USB

Port

GPS Antenna

Connector

GPS Antenna

Status LEDs

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 117 118

Komentarze do niniejszej Instrukcji

Brak uwag