Sharp IQ-8000 Instrukcja Instalacji Pobierz pdf (Strona 103)

9.2.5.1 Four-Reader Expansion Board (P/N: 03-10102-301E) - Jumper Selections

There are five jumper units located on the 4-Reader Expansion PCB circuit board. The settings are

shown below.

•

W1 at Pins 2 and 3 = PCB addressed to High Address Range

•

W1 at Pins 1 and 2 = PCB addressed to Low Address Range

•

W5 (for Readers e-h)

•

At pins 1 and 2, 4 and 5, 7 and 8, 10 and 11= Wiegand 5-Wire 5 volt card readers

•

At pins 2 and 3, 4 and 5, 7 and 8, 10 and 11= Wiegand 5-Wire 12 volt card readers

•

At pins 2 and 3, 5 and 6, 8 and 9, 11 and 12= PCSC 4-Wire 12 volt card readers

•

W6 – Reader T/O

•

At pins 1 and 2 = 32 ms (PCSC Factory Set. Do not

modify)

•

At pins 2 and 3 = 64 ms

•

W11-W14 Reader Data Format

•

At pins 1 and 2 = Wiegand 5-wire (Data 1’s and Data 0’s) format

•

At pins 2 and 3= PCSC 4-wire (proprietary) format

•

SW1 Switch Settings (to configure PCB for doors 5-8)

•

Switch 2 = OFF

•

Switches 1,3,4,6,7,8 = ON = 4 Reader PCB

•

Switch 5 = ON to enable Supervision Option of ALL Egress Sense Inputs (#24, 26,

28, and 30).

•

Switch 5 = OFF to disable Supervision of ALL Egress Sense Sense Inputs (#24, 26,

28, and 30).

NOTE Supervised Egress Option requires i4+07.010.02 series (or newer) IQ-400 firmware.

Page xc of 110 IQ-400 Installation Manual 33-10057-001-C

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 124 125

Brak uwag

Sharp IQ-8000 Instrukcja Instalacji Strona 103