Sharp CP-C405 Instrukcja Obsługi Pobierz pdf (Strona 13)

CPD-200GS

2-2

3 When one side of the rubber cap is

separated from the anode button, the

anode-cap can be removed by turning

up the rubber cap and pulling up it in the

direction of the arrow c.

• HOW TO HANDLE AN ANODE-CAP

1 Don’t hurt the surface of anode-caps with shartp shaped material!

2 Don’t press the rubber hardly not to hurt inside of anode-caps!

A material fitting called as shatter-hook terminal is built in the

rubber.

3 Don’t turn the foot of rubber over hardly!

The shatter-hook terminal will stick out or hurt the rubber.

• REMOVAL OF ANODE-CAP

NOTE: Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or carbon painted on the CRT, after

removing the anode.

• REMOVING PROCEDURES

1 Turn up one side of the rubber cap in

the direction indicated by the arrow a.

2 Using a thumb pull up the rubber cap

firmly in the direction indicated by the

arrow b.

Anode Button

2-4. PICTURE TUBE REMOVAL

• Remove the D, A and J boards (Refer to 2-3.)

Anode cup

Cushion

Neck assy

Deflection yoke

Picture tube

Picture tube shield

Four screws

(Tapping screw 5)

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 33 34

Brak uwag

Sharp CP-C405 Instrukcja Obsługi Strona 13