Sharp FODC600 Instrukcja Użytkownika Pobierz pdf (Strona 77)

Setting the IP Address

3. Network

Scanner

Wait while the machine writes the setting to the NIC board (“DO NOT

POWER DOWN” will appear in the display). When the display changes to

“OK”, turn off the power of the machine and then turn it back on to make

the new settings take effect. (Before turning off the power, make sure

the machine is not in the middle of a job: 1) check whether the machine

is printing, and 2) press

and check the display to see if the

machine is sending or receiving a fax

JOB STATUS

Initializing the network interface card

Normally the network interface card (NIC) does not need to be initialized

(returned to the factory default settings). In the event that you do need to

intialize the card, follow the Steps 1 to 3 of the previous procedure to access

“NETWORK CONFIG SET”, press to select “INTIALIZE THE NIC”, and

then press . Press to select “YES” and then press . Wait

while the machine writes the setting to the NIC board (“DO NOT POWER

DOWN” will appear in the display). When the display changes to “OK”, turn off

the power of the machine and then turn it back on to make the new setting

take effect. (Before turning off the power, make sure the machine is not in the

middle of a job: 1) check whether the machine is printing, and 2) press

and check the display to see if the machine is sending or receiving a

fax

START/

ENTER

START/

ENTER

JOB STATUS

all.bookPage75Wednesday,December18,20028:17AM

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 219 220

Brak uwag

Sharp FODC600 Instrukcja Użytkownika Strona 77