Sharp R-362M Instrukcja Obsługi Pobierz pdf (Strona 47)

MS 362 C

English

45

N Use a screwdriver to remove the E-

clip (1)

N Remove the washer (2)

N Remove rim sprocket (3)

N Inspect transport profile on the

clutch drum (4) – if there are also

heavy signs of wear, also replace

the clutch drum

N Remove clutch drum or spur chain

sprocket (5) including needle

cage (6) from the crankshaft – with

versions with two chain brake

systems, press throttle lock

beforehand

Install spur chain sprocket / rim

sprocket

N Clean crankshaft stub and needle

cage and lubricate with STIHL

lubricant (special accessory)

N Slide needle cage onto the

crankshaft stub

N After refitting, turn the clutch drum

and/or spur chain sprocket approx.

1 full turn so that the carrier for the

oil pump drive engages

N Refit the rim sprocket – cavities

toward the outside

N Refit washer and E-clip on the

crankshaft

Cutting effortlessly with a correctly

sharpened chain

A properly sharpened chain slices

through wood effortlessly and requires

very little feed pressure.

Do not work with a dull or damaged

chain as it will increase the physical

effort required, produce unsatisfactory

results and a higher rate of wear.

N Clean the chain.

N Check the chain for cracks in the

links and damaged rivets.

N Replace any damaged or worn

parts of the chain and match the

new parts to the shape and size of

the original parts.

The chain pitch (e.g. 3/8") is marked on

the depth gauge end of each cutter.

001BA122 KN

1

2

4

5

6

1

2

3

6

Maintaining and

Sharpening the Saw Chain

It is absolutely essential to comply

with the angles and dimensions

specified below. If the saw chain is

incorrectly sharpened – and in

particular if the depth gauge is set

too low – there is a risk of

increased kickback of the saw,

with resulting risk of injury.

3/8

689BA020 KN

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 123 124

Komentarze do niniejszej Instrukcji

Brak uwag