Sharp IQ-8000 Instrukcja Obsługi Pobierz pdf (Strona 23)

CarboVis 70x IQ TS Commissioning

3 - 13

ba75950e02 11/2012

Fig. 3-7 140 - Settings of sensors and diff. sensors (virtual sensor)

3.4.5 Settings of the secondary sensor (TSS measurement)

Carrying out settings Using <S>, switch from the measured value display to the main menu

of the settings. Then navigate to the setting menu (setting table) of the

sensor. The procedure is described in detail in your IQ S

ENSOR NET

system operating manual.

Default values are marked in bold.

Save and quit -

The system confirms the saving of the

settings and the display switches to the

next higher level.

Quit -

The display switches to the next higher

level without saving the new settings.

Menu item Settings Explanations

Measuring mode TSS

Display of the measuring mode

(TSS = total suspended solids measure-

ment)

Measuring range

Display of the measuring range

(see chapter 8 T

ECHNICAL DATA).

Cal - # raw value 1

Value pairs of the user calibration for TSS measurement (see section

4.3.2).

Note:

Leave those values unchanged during the initial commission-

ing.

Cal - ref. value 1

Cal - # raw value 2

Cal - ref. value 2

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 65 66

Brak uwag

Sharp IQ-8000 Instrukcja Obsługi Strona 23