Sharp AR-650 Instrukcja Obsługi Pobierz pdf (Strona 122)

7 - 19 SCANNER

[C] Exposure lamp

(1) Move the carriage to the center.

(2) Remove the reflector (Upper) (2 screws).

(3) Loosen the front side screw fixing the holder.

(4) Remove the exposure lamp from the blade.

Note: When installing the exposure lamp on the

holder, face the projection of the lamp op-

posite to the reflector. Do not touch the glass

surface of the exposure lamp with your bare

hand.

[D] Thermostat

(1) Remove the screw and draw out the thermo-

stat from the carriage.

(2) Release the harness from the terminal, and

remove the thermostat.

Note: If the thermostat has been used once, it

should be replaced with a new one, because

it is designed basically for one-time use only.

Do not push the reset pin to reuse a ther-

mostat that has been operated once.

Carriage

Exposure lamp

Blade Blade

Holder

Terminal

Thermostat

Exit side

Reflector(Lower)

Reflector(Upper)

Protrusion

Lamp

(4) Remove the APS cover (2 screws).

(5) Remove the screw, disconnect the connector

and remove the harness from the 3 clamps

(base side). Then remove the automatic paper

size detector.

A4 series : 6 pcs.

LT series : 4 pcs.

APS cover

Clamp

1 2 ... 117 118 119 120 121 122 123 124 125 126 127 ... 395 396

Komentarze do niniejszej Instrukcji

Brak uwag