Sharp SF-2530 Instrukcja Użytkownika Pobierz pdf (Strona 25)

Main code Sub code Description Ref. Page

26 06 Destination setup

Used to set the destination setting.

1 When the test command is executed, the presently stored model number and the destination code

are displayed (see table below) and the READY lamp turns on.

2 After the READY lamp has turned on, enter the model number and the destination code on the

keypad and press the PRINT switch to store the setting in the memory. The READY lamp then

turns off.

Code Destination AB/Inch

0 SEC (ES) America

(Inch)

1 SEC America

2 SECL Canada

3 Other

4 Japan

(AB Japan)

5 Other

6 SEEG German

(AB Export)

7 SUK U.K.

8 SCA Australia

9 Other

10 BW-UT1 Taiwan

07 Drum sensitivity setup

1 When the test command is executed, the number stored in the memory is recalled and the READY

lamp turns on.

2 A number 1 to 3 may be entered on the keypad while the RPL is active.

3 Press the PRINT switch after the number has been entered. With this, the READY lamp turns off

and the test command number is displayed.

Drum

Keypad entry 1 2 3

Sensitivity 1 2 3

08 Lens characteristics entry (at a time of lens replacement)

Because each lens has a variance in focal distance, the lens moving distance in any zoom mode must

correspond with the focal distance of the lens. The zoom ratio varies proportionate to the variance of

the lens focal distance.

To avoid focus problem, the class of the lens focal distance (refer to chart on page 7-11) is stored in the

memory using the test command. In a variable zoom mode, the lens moving distance that corresponds

to the lens focal distance is obtained on the basis of the data so as to produce the accurate zoom copy.

[7]-10-(6)

Setup method (26-08)

1 When the test command is executed, the presently stored preset code is displayed and the READY

lamp turns on.

2 After the READY lamp turned on, enter the lens number shown on the top of lens area and press

the PRINT switch to store the value in the memory. The READY lamp now turns off.

C → =↵ → 0/◊ → =↵ → 2 → 6 → PSW → 8 → PSW → 1

→ 4 → PSW

09 4/5 mirror characteristics entry (at a time of lens replacement)

(Setup method (26-09)

[7]-10-(6)

1 Set the correction value for lens marked value based on "lens value vs. test command input."

Press C → =↵ → 0/◊ → =↵ → 2 → 6 → PSW → 9 → PSW keys to execute

the test command 26-09.

As the READY lamp turns on, the previously set value 1 to 21) is shown.

2 Enter the new value on the keypad.

EX: If the value shown on the lens is +1, 2, pick up "14."

Press the 1 → 4 → PSW keys.

A figure 0 to L is shown on the lens value label.

82525

No. 114191

O-L

+1.2

12/28/1998

SF-2530

8 – 13

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 33 34

Komentarze do niniejszej Instrukcji

Brak uwag

Sharp SF-2530 Instrukcja Użytkownika Strona 25

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Kopiarki Sharp SF-2530